Intec K10000-02 Guide d'installation télécharger pdf

Operation and Safety Guide

Model # K10000-02

Tool Application: Overview of system

http://www.inteccorp.com/force1/

Tool Operation:

Step

Action

Unload the machine using safe lifting techniques. Position

the machine in a dry, hazard free environment to allow for

suitable material feed and access to electrical power. Note:

At cold temperatures below 35 F, oil thickens and will cause

machine to start up hard. To prevent hard startup, leave

machine in warm area overnight (8 hours).

Secure 100 feet of blowing hose to machine outlet with a

hose clamp.

Remove slide gate locking pin, open the slide gate to the last

hole position for attic blow & re-insert locking pin. (See

owner’s manual for wall applications.)

Ensure all controls – both on control panel and remote -- are

in the “off” position.

Connect the machine’s power cord to a dedicated circuit –

115V 20amp or 15amp.

To power machine, first turn the control panel’s blower switch

to the “on” position, then the agitator switch to the “on”

position. Now use the remote switches to first turn the

blower, then agitator “on”. When turning machine “off”, turn

agitator “off” first, then blower.

Open a bag of insulation and feed the insulation material into

the hopper. Do not let the plastic bag or other foreign objects

fall into the hopper; do not force feed insulation.

At completion, use the remote or control panel switch to turn

machine off. Remove any insulation still in the system.

Return machine, hose, wired remote, and power cord to the

rental center from which it was obtained.

SAFETY TOPICS:

To avoid personal injury, do not attempt to operate this

equipment until you thoroughly read and completely

understand the operator’s manual. Please visit

http://www.inteccorp.com/force1/ for additional

information.

SAFETY CHECKLIST:

1. Read all the instructions before using the insulation

blower.

2. To reduce the risk of injury, close supervision is

necessary when an insulation blower is used near

children.

3. Do not contact moving parts.

4. Only use attachments recommended or sold by the

manufacturer.

5. Use of Extension and Power Cord:

a) This product requires the use of a power cord. In

addition to the supplied power cord, care should be

exercised in the selection and use of an extension

cord.

b) The extension cord shall be a grounded 3-wire cord.

c) The extension cord should be arranged so that it will

not drape over the countertop or tabletop where it

can be tripped over, snagged, or pulled on

unintentionally (especially by children).

d) An outdoor rated extension cord should be used with

this machine. An outdoor- use extension cord is

marked with suffix letter “W” and with a tag stating

“Suitable for Use with Outdoor Appliances.”

e) The marked electrical rating of the extension cord

shall be rated for at least 15 amps.

f) To unplug or disconnect: Put the blower and agitator

control panel and remote buttons in the stop position

before removing plug from outlet.

g) Do not unplug by pulling on the power cord. To

unplug, grasp the male and female plugs and pull

apart.

h) Unplug from outlet when not in use and before

servicing or cleaning.

i) Do not operate any insulation blower with a damaged

cord or plug, or after the machine malfunctions or is

dropped or damaged in any manner.

6. In the case of a non-operable or malfunctioning blower,

return the insulation blower to the nearest authorized

service facility for examination, repair, or electrical or

mechanical adjustment.

7. Store insulation blower indoors when not in use. Keep

out of the reach of children

8. Never operate this equipment if the operator or the

machine is standing in water, snow or rain. Do not clean

this insulation blower with water spray or the like.

9. Connect to a properly grounded outlet only.

10. Wear long sleeve shirt, gloves, a hat, safety glasses or

goggles, and a nose & mouth dust mask.

WARNING:

1. Never reach into the hopper when system is operating.

2. Keep all foreign materials out of hopper.

3. Stop all motors and disconnect power cord before

attempting to remove a foreign object or jam.

4. Never point insulation hose in direction of people or

pets.

Vendor Website: www.inteccorp.com Support Phone No. 800-666-1611

Operation and Safety Guide 1

Résumé du contenu

Page 1 - Operation and Safety Guide

Operation and Safety Guide Model # K10000-02

Commentaires sur ces manuels

Pas de commentaire

Intec K10000-02 Guide d'installation

Naviguer en ligne ou télécharger Guide d'installation pour Ventilateurs et séchoirs à air Intec K10000-02. Intec K10000-02 Installation Guide Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Ventilateurs et séchoirs à air Intec K10000-02