Intec K30000-01 Guide d'installation télécharger pdf (Page 10)

THE SYSTEM

FORCE

/3 3.0 & 4.0 DP

The System

Three sub-systems make up your FORCE/3:

THE AGITATOR AND AIRLOCK.

The FORCE/3 uses a 1-

⁄2hp

motor and is coupled to a worm gearbox to reduce the speed of the

motor and increase torque. In addition to the motor and gearbox, chain

and sprockets are used to further reduce the speed of the airlock.

THE BLOWER MOTOR(S).

The FORCE/3 3.0 is equipped with two

5.7" 128 CFM three stage blowers to push the material through the hose

and into the attic with optimum pressure and output. The Force/3 4.0 DP

is equipped with two 116 CFM two stage blowers which produce over 4.0

PSI through the airlock.

ELECTRICAL SYSTEM.

The FORCE/3 3.0 requires 2 separate

dedicated 20 amp grounded circuits.

Low voltage or amperage may likely

cause tripping (blowing) of house

circuit breakers or chattering of

contactor (relay). The Force/3 4.0 DP

requires 2 dedicated circuits, 20 & 30

amp. Due to the high current draw of

this machine you will need to use a

10.5KW generator to properly operate it. Never attempt to operate the

FORCE/3 in standing water!

Always disconnect all power to the equipment before attempting

repair; otherwise bodily injury or death may result.

THE PARTS.

1. Hopper: upper component of the FORCE/3 where insulation is

loaded.

2. Frame: Lower part of the machine that supports the entire

machine.

3. Side panels: surround the outside of the machine to aid in

protection during operation.

4. Electrical: on/off function for both the blower and agitator motors.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 37 38

Pas de commentaire

Intec K30000-01 Guide d'installation Page 10